190
Sensor Input Setting Ranges/Control Ranges Appendix B
Advanced Function Setting Level
Parameter No. 1 display:
Characters
No. 2 display:
Default
Set (monitor) value
Parameter initialize init off on: All parameters initialized
off: Returns to after
off initializing
Number of multi-SP uses eU-m 0 0: No multi-SP uses
1: Switch between SP0 and SP1
Event input allocation eU none none: Disabled
stop: RUN/STOP
Multi-SP used mspu off off: Multi-SP disabled
on: Multi-SP enabled
SP ramp set value sprt 0 1 to 9999
0: SP ramp function disabled
Standby sequence reset
method
rest a a: Condition A
b: Condition B
Alarm 1 open in alarm al1n n-o n-o: Excitation
n-c: Hysteresis
Alarm 1 hysteresis alh1 0.2 0.1 to 999.9
Alarm 2 open in alarm al2n n-o n-o: Excitation
n-c: Hysteresis
Alarm 2 hysteresis al2h 0.2 0.1 to 999.9
Alarm 3 open in alarm al3n n-o n-o: Excitation
n-c: Hysteresis
Alarm 3 hysteresis al3h 0.2 0.1 to 999.9
HBA used hbu on off: Not used
on: Used
(pulse output models only)
Heater burnout latch hbl off off: Disabled
on: Enabled
(pulse output models only)
Heater burnout hysteresis hbh 0.1 0.1 to 50.0 (pulse output models only)
α alfa 0.65 0.00 to 1.00
MV upper limit ol-h 105.0 Standard control: Operation lower limit +0.1
to 105.0
Heating and cooling control:0.0 to 105.0
MV lower limit ol-l -5.0 Standard control: −5.0 to operation limit −0.1
Heating and cooling control: −105.0 to 0
Input digital filter inf 0.0 0.0 to 999.9
Additional PV display pUad off off: Not added
on: Added
Additional temperature input
shift value display
isdp off off: Not displayed
on: Displayed
Temperature input shift type istp 0 0: One-point temperature input shift
1: Two-point temperature input shift
(upgraded pulse output models and analog
output models only)
Alarm 1 latch a1lt off off: Disabled
on: Enabled
Alarm 2 latch a2lt off off: Disabled
on: Enabled
Alarm 3 latch a3lt off off: Disabled
on: Enabled
To Next Page
Loading...
