Omron FQ-CR2 - Page 128

Outputting/Controlling with Ethernet
126
FQ-CR2 User’s Manual
Command List
The following table lists the no-protocol commands.
Commands that can be used in no-protocol Ethernet communications are listed below.
Type of command Command Abbreviation Function Reference
Scene control com-
mands
SCENE S or SN Acquires the current scene
number.
p. 127
SCENE Scene_number S Scene_number or SN
Scene_number
Changes the scene number
being used.
p. 128
Measurement control
commands
MEASURE M Executes one measurement. p. 129
MEASURE/C M/C or GC Starts continuous measure-
ments.
p. 130
MEASURE/E M/E or SC Ends continuous measure-
ments.
p. 131
TEACH FT Executes 2D code teaching. p. 132
Data acquisition/setting
commands
LASERTIME LT Acquires the shutter time. p. 133
LASERTIME Set_value LT Set_value Sets the shutter time. p. 134
GAIN GN Acquires the gain. p. 135
GAIN Set_value GN Set_value Sets the gain. p. 136
BRIGHTNESS BN Acquires the brightness. p. 137
BRIGHTNESS Set_value BN Set_value Sets the brightness. p. 138
FILTERDATA
External_reference_data_nu
mber
FD
External_reference_data_nu
mber
Acquires filter setting informa-
tion.
p. 139
FILTERDATA
External_reference_data_nu
mber
Set_value
FD
External_reference_data_nu
mber
Set_value
Sets filter setting information. p. 140
ITEMDATA
Inspection_item_number
External_reference_data_nu
mber
ID Inspection_item_number
External_reference_data_nu
mber
Acquires the inspection item
data.
p. 141
ITEMDATA
Inspection_item_number
External_reference_data_nu
mber
Set_value
ID Inspection_item_number
External_reference_data_nu
mber
Set_value
Sets the inspection item data. p. 142
ITEMDATA2
Inspection_item_number
External_reference_data_nu
mber
ID2 Inspection_item_number
External_reference_data_nu
mber
Acquires the text string of the
inspection item data.
p. 143
Setting acquisition com-
mand
VERGET/S VR Acquires the version informa-
tion of the Sensor software.
p. 144
VERGET/H None Acquires the Sensor model
information.
p. 145
ERRGET None Acquires the latest error code
of the Sensor.
p. 146
SAVEALLDATA SV Saves all sensor information. p. 147
Utility
comman
ds CLRMEAS None Clears the measurement val-
ues.
p. 148
CLRERR None Clears the error output status
(error signal and error indica-
tor).
p. 149
RESET None Restarts the Sensor. p. 150
Sec8.fm 126 ページ ２０１１年７月８日 金曜日 午後４時２３分