Omron FQ-CR2 - Basic Operational Flow; Installation and Connections

Basic Operational Flow
16
FQ-CR2 User’s Manual
1-4 Basic Operational Flow
The following flow shows the basic operation of FQ-CR2 Sensors.
*1: In Setup Mode, the Sensor can be set up and adjusted, but it does not output signals on the I/O lines.
*2: In Run Mode, the Sensor performs measurements and outputs signals on the I/O lines.
Operation
*2
Starting Operation (Run Mode)
Saving the Settings
Test Measurement and
Results Verification
Testing ([Test] Tab Page)
Output Settings
([In/Out] Tab Page)
Setup Evaluation
*1
Inspection Setup
([Inspect] Tab Page)
Teaching
Registering
Inspection Items
Image Setup
([Image] Tab Page)
Starting the Sensor
Connections and Wiring
Inspection
Section 2 Installation
and Connections
Section 1
1-3 Startup Display
and Display Elements
Section 3 Taking
Images
Section 4 Setting Up
Inspections
Section 8
Communications w ith
External Devices
Section 5 Testing and
Saving Settings
Section 6 Operation
FQ Sensor User Manual.book 16 ページ ２０１１年７月８日 金曜日 午後２時３０分