Omron FQ-CR2 - Changes the Scene Number

Outputting/Controlling with Ethernet
128
FQ-CR2 User’s Manual
Change Scene Number
This command changes the scene number to use.
<Command Format>
<Response Format>
When the Command Is Processed Normally
When the Command Is Not Processed Normally
<Parameter Descriptions>
Scene number Specifies the scene number (0 to 31) to change to.
S C CR E N E
or
Scene number
(2 digits max.)
Delimiter Delimiter
CR S
Scene number
(2 digits max.)
or
Delimiter
CR S N
Scene number
(2 digits max.)
CR OK
Delimiter
CR ER
Delimiter
FQ Sensor User Manual.book 128 ページ ２０１１年７月８日 金曜日 午後２時３０分