Omron FQ-CR2 User Manual

Outputting/Controlling with Ethernet
130
FQ-CR2 User’s Manual
Start Continuous Measurements
This command starts continuous measurements.
If Ethernet output is not set, only continuous measurement is performed.
If Ethernet output is set, continuous measurement is performed and the results corresponding to the number of
measurements made are returned as response data.
<Command Format>
<Response Format>
When the Command Is Processed Normally
When the Command Is Not Processed Normally
<Parameter Descriptions>
Measurement result The measurement results corresponding to the number of measurements made are out-
put when Ethernet output is set.
The measurement result is not output when Ethernet output is not set.
Reference: Setting the Data to Output via Ethernet (p. 120)
A S M E CR U R E / C
Delimiter
CR M/C
Delimiter
or
CR GC
Delimiter
or
CR
CR
CR
OK
CR
Delimiter
Data returned for the
number of continu-
ous measurements
made.
Measure-
ment result
Measure-
ment result
Measure-
ment result
CR ER
Delimiter
FQ Sensor User Manual.book 130 ページ ２０１１年７月８日 金曜日 午後２時３０分

Omron FQ-CR2 Specifications

General

Brand	Omron
Model	FQ-CR2
Category	Barcode Reader
Language	English