Oracle SPARC T5-2 - Locate a Failed DIMM (LEDs)

DIMM Rank Classification Labels
Related Information
■
“Memory Riser and DIMM FRU Names” on page 97
■
“DIMM Rank Classification Labels” on page 100
■
“Locate a Failed DIMM (LEDs)” on page 100
■
“Remove a Memory Riser and DIMM” on page 103
■
“Install a DIMM and a Memory Riser” on page 106
DIMM Rank Classification Labels
Each DIMM is shipped with a label identifying its rank classification. The following table
identifies the corresponding rank classification label shipped with each DIMM.
Note - Single-rank DIMMs are not currently offered.
DIMM Capacity DRAM Density Rank Classification Label
8 GB 4 GB Dual-rank x4 2Rx4
16 GB 4 GB Dual-rank x4 2Rx4
32 GB 4 GB Quad-rank x4 4Rx4
Related Information
■
“Memory Riser and DIMM FRU Names” on page 97
■
“Memory Riser and DIMM Configuration” on page 99
■
“Locate a Failed DIMM (LEDs)” on page 100
■
“Remove a Memory Riser and DIMM” on page 103
■
“Install a DIMM and a Memory Riser” on page 106
Locate a Failed DIMM (LEDs)
Each memory riser has a Remind button, a Power LED, and Fault LEDs adjacent to each
DIMM. This procedure describes how to identify a faulty DIMM using these buttons and LEDs.
100 SPARC T5-2 Server Service Manual • February 2017