Locate the Server
Related Information
■
“Front Panel Components (Service)” on page 13
Locate the Server
You can use the Locator LEDs to identify one particular server from many other servers.
1.
At the Oracle ILOM prompt, type:
-> set /System/locator_indicator=on
The white Locator LEDs (one on the front panel and one on the rear panel) blink.
2.
After locating the server with the blinking Locator LED, turn it off by pressing the
Locator button.
Alternatively, you can type an Oracle ILOM command to turn off the Locator LED.
-> set /System/locator_indicator=off
Related Information
■
“Front Panel Components (Service)” on page 13
Component Service Categories
The server components and assemblies that can be replaced in the field fall into three
categories:
■
Hot-service, replaceable by customer
■
Cold-service, replaceable by customer
■
Cold-service, replaceable by authorized service personnel
Cold service procedures require that you shut the server down and unplug the power cables that
connect the power supplies to the power source.
Although hot service procedures can be performed while the server is running, you should
usually bring it to standby mode as the first step in the replacement procedure. Refer to “Power
Off the Server (Power Button - Graceful)” on page 60 for instructions.
Preparing for Service 57
To Next Page
Loading...
Need help?
General