Oracle SPARC T5-2 - Verify Drive Functionality

Verify Drive Functionality
3.
Install the drive by completing the following tasks.
a.
Slide the drive filler panel into the drive slot until it is fully seated.
b.
Close the latch to lock the filler panel in place.
Related Information
■
“Locate a Faulty Drive” on page 71
■
“Remove a Drive” on page 71
■
“Install a Drive” on page 76
■
“Remove a Drive Filler Panel” on page 74
■
“Verify Drive Functionality” on page 78
Verify Drive Functionality
1.
If the OS is shut down, and the drive you replaced was not the boot device, boot
the OS.
Depending on the nature of the replaced drive, you might need to perform administrative tasks
to reinstall software before the server can boot. Refer to the Oracle Solaris OS administration
documentation for more information.
78 SPARC T5-2 Server Service Manual • February 2017