Install a Power Supply
5.
Install a new power supply.
See “Install a Power Supply” on page 93.
Related Information
■
“Locate a Faulty Power Supply” on page 91
■
“Install a Power Supply” on page 93
Install a Power Supply
Caution - Install an A239A power supply, labeled for upright installation, in the server. The
A239A power supply correctly exhausts air from the rear of the server. Do not install an A239
power supply, which might cause the server to overheat and shut down.
1.
Remove a power supply.
See “Remove a Power Supply” on page 91.
2.
If necessary, release the cable management arm to access the power supplies.
See “Release the CMA” on page 64.
Do not allow the CMA to hang unsupported while it is unattached.
3.
Align the power supply with the empty power supply chassis bay.
4.
Slide the power supply into the bay until it is fully seated.
Servicing Power Supplies 93
To Next Page
Loading...
Need help?
General