Oracle SPARC T5-2 - Page 94

Install a Power Supply
5.
Move the release latch up to secure the power supply in place.
6.
Reconnect the power cord to the power supply.
7.
Verify that the AC OK LED is lit.
See “Locate a Faulty Power Supply” on page 91.
8.
Verify that the following LEDs are not lit:
■
Service Action Required LED on the power supply
■
Front and rear Service Action Required LEDs
■
Rear PS Failure LED on the bezel of the server
See “Interpreting LEDs” on page 36.
9.
Verify power supply functionality.
See “Verify Power Supply Functionality” on page 95.
Related Information
■
“Remove a Power Supply” on page 91
■
“Verify Power Supply Functionality” on page 95
94 SPARC T5-2 Server Service Manual • February 2017