Oval ALTI mass CA00A - Transition Chart of View (4)

L
--
740
--
28
--
E

NOTE:
9.2.5 Transition chart of view (4)
MODE SELECT
Process screen
1.Password & Disp
2.Setup
1.Flow Param
2.DensParam
3.Temp Param
4.Outputs
1.Ana. Output1
2.Ana. Output2
3.Pls. Output1
4.Pls. Output2
5.Status Output
1.Function
2.Select
1.Sensor Fail
2.Txr Fail
3.Cal Fail
4.Satura. Alm.
5.Param Alm.
6.Txr Alm.
7.Slug Alm.
8.Cal in prog.
9.Fix Output
Exit
4.Mode
Exit
1.Analog
2.Pulse
Exit
Exit
6.Error Output
1.Function
2.Mode
Exit
1.Assign
2.H/L Alm. Type
3.High Alm. Po.
4.Low Alm. Po.
5.H/L Alm. hys
Exit
Exit
4.Maintenance
3.Diag/Service
5.Status Input
6.H/L Alarm
Exit
： "SEL1" operation
： "SEL3" operation (For operating procedure, see 9.1.2 Switching operation.)
： "ENT" operation
3.Drive Output Po.
※1
※1：For this function, the setting change is disabled in Write Protect mode (refer to section 9.2).