Panasonic KX-TD500 - Page 36

Configuration
36 Programming Guide
Parameter Type
Default CO
Value Range
1. CO
2. EXT
3. Qsig – Master
4. Qsig – Slave
Description/Function Specifies the type of each PRI port on a PRI port basis.
Notes
• When you change the programming data, the status of the
card must be made OUS (Out-of-Service), and then INS (In-
Service).
• The type of PRI port can be assigned per PRI23/PRI30 card.
• This setting is valid when the LPR software version of the
PRI23/PRI30 card is "Q361AB"/"Q341AC" or later
respectively.
Reference • 2.1 ISDN Features (F/G)
– Integrated Services Digital Network (ISDN)
– Integrated Services Digital Network (ISDN) Extension
• 3.1 TIE Line Features (F/G)
– TIE Line Service
• 4.7 ISDN Extension Line (P/G)
Parameter DN
Default Blank
Value Range 3-4 digits consisting of 0-9 or X
Description/Function Specifies the DN (Directory Number) for the PRI port.
(Assignable only when "EXT" is specified in "Type" assignment.)
Notes
• "X" can be used as a wild card character which substitutes
any digit in its position. The last one or two digits of DN may
be "X."
• This setting is valid when the LPR software version of the
PRI23/PRI30 card is "Q361AB"/"Q341AC" or later
respectively.
Reference • 2.3 Numbering Plan (P/G)