• System Port (P3) Set-up A-6
• UDP Transfer Procedure A-6
• MMI Dump Procedure A-7
DSELite Support A-8
• System Port (P3) Set-up A-8
5703 Support A-9
• System Port (P3) Set-up A-11
EI Bisynch ASCII Support A-12
• System Port (P3) Set-up A-12
EI Binary Support A-17
• System Port (P3) Set-up A-17
• EI Bisynch Binary Message Protocol A-19
• EI Bisynch Binary Parameter Specification Tables A-23
Error Codes A-32
• ERROR REPORT (EE) A-32
APPENDIX B CERTIFICATION .................................... B-1
Introduction ..............................................................................B-3
Europe .....................................................................................B-3
What are the European Directives? B-3
CE Marking for the Low Voltage Directive (LVD) 2006/95/ECB-4
CE Marking for the EMC Directive 2004/108/EC B-4
United States of America & Canada..............................................B-6
Compliance B-6
Conditions for Compliance with UL508c B-6
• Solid-State Motor Overload Protection B-6
• Branch Circuit/Short Circuit Protection Requirements B-7
• Short Circuit Rating B-8
• Field Wiring Temperature Rating B-8
• Operating Ambient Temperature B-8
• Field Wiring Terminal Markings B-8
• Power and Control Field Wiring Terminals B-8
• Field Grounding Terminals B-9
• Field Terminal Kits B-9
• Fuse Replacement Information B-9
Australia & New Zealand ........................................................ B-10
EMC Standards B-10
EMC ...................................................................................... B-11
Emissions Limits B-11
EMC General Installation Considerations B-13
• Earthing Requirements B-13
• Increasing Motor Cable Length B-14
Certificates............................................................................. B-15
APPENDIX C PARAMETER SPECIFICATION TABLES.....C-1
Parameter Tables......................................................................C-3
Specification Table: Tag Number Order .....................................C-4
Parameter Table: MMI Menu Order ........................................C-27
APPENDIX D PROGRAMMING .................................. D-1
Programming Your Application..................................................D-3
Programming with Block Diagrams D-3
• Modifying a Block Diagram D-3
• Saving Your Modifications D-6
• Understanding the Function Block Description D-6
• MMI Menu Maps D-7
• Function Blocks By Category D-8
• Compatibility with Earlier Versions of Firmware D-9
Function Block Descriptions .....................................................D-12
• 5703 IN D-12
• 5703 OUT D-13
• ADVANCED D-14
• ALARM HISTORY D-17
• ALARMS D-18
• ANALOG INPUTS D-23
• ANALOG OUTPUTS D-25
• AUTOTUNE D-26
• AUX I/O D-28
• CALIBRATION D-29
• CONFIGURE DRIVE D-32
• CURRENT LOOP D-33
To Next Page
Loading...
