1-98 Programming Your Application
690+ Series Frequency Inverter
Parameter Descriptions
SEQUENCER STATE
Range: Enumerated - see below
This parameter indicates the current sequencing state:
Enumerated Value : State
0 : START DISABLED
1 : START ENABLED
2 : SWITCHED ON
3 : READY
4 : ENABLED
5 : F-STOP ACTIVE
6 : TRIP ACTIVE
7 : TRIPPED
Refer to Chapter 4: “Sequencing Logic States”.
REMOTE REV OUT
Range: FALSE / TRUE
This parameter indicates the current state of remote direction and RUN REV. Note - this is the
demanded direction, not the actual direction.
HEALTHY
Range: FALSE / TRUE
Set FALSE when the Inverter trips, and set TRUE when the run command is removed.
FAN RUNNING
Range: FALSE / TRUE
This can be used to control the running of externally supplied fans. True when the drive is
running, goes FALSE 60 seconds after the drive has stopped.
To Next Page
Loading...
