103
Press the [ENT] to view the AIM AT THE
REFERENCE POINT screen.
Aim at the previous station, then press [ENT].
The direction angle is set automatically.
It proceeds to MEASURE screen automatically.
Press [F3][MEAS] to confirm the points to be aimed
For more details, refer to “4.2 Station Orientation”.
Measuring
Aim at the Target point and press [F1][MEAS] to
measure the distance.
Press [F3][ME/SAVE] to measure and save the
measured data as sideshot point.
Press [F2][SAVE] to save the measured data as sideshot point.
When no PN is input, no survey data is saved.
Press the [F4][EDIT] to edit the PN, Point Name,
PH, Prism Height and PC, Point Code.
Press [ENT] to view each input window by pressing
the up or down arrow key, and input your desired
point name or prism height or point code. Press the
[F5][ACCEPT], if the current PN, PH and PC are acceptable.
Press the [ENT] to save the measured data as corner point.
If [ENT] is pushed more than twice at the one station, the last [ENT] point becomes next
corner point.
NOTE: Please use [SAVE] [ME/SAVE] and [ENT] properly by sideshot and corner point.
Press [F5][PAGE] to view another menu.
To finish the traverse measurement
Fixed traverse
Please measure the known point and press [ENT] at the last corner point.
Closed traverse
Please measure the start point and press [ENT] at the last corner point.
To Next Page
Loading...
