Pentax R-2500NS Series - Point Name Input; IH, TEMP, PRESS, Ppm and PC Input

29
The [ ] / [ ] mark is used to scroll up / down.
4.5.1 Point name input
Select 1.PN to display PN input screen.
Input PN value.
Press [ENT].
4.5.2 IH, TEMP, PRESS, ppm and PC input
Input IH value.
Press [ENT].
Input the PC.
Press [ENT] to view and input the PC, Point code,
screen.
If PointCode exists, you can easily select it from the
list or edit one of them after pressing [ENT].
For using Point Code List, please refer to“5.4.1
Point Code”.
If “PROCESS TYPE” is selected in “Action method selection”, the input point data will
be stored in the memory with [SAVE]. Then the panel “STATION POINT H.ANGLE
SETUP” will be displayed without pressing [ACCEPT].
But, if “STRUCTURE TYPE” is selected in “Action method selection”, it is necessary to
press [ACCEPT] to proceed to next panel.
Input the TEMP value.
Press [ENT].
Input the PRESS value.
Press [ENT].