17
3.4.2 Deletion from a Job name search
Select 2. JOB NAME SEARCH by pressing the
down arrow key.
Press [ENT] to view the JOB NAME INPUT screen.
Input your desired JOB NAME to delete and press
[ENT] to view the DELETE JOB CONFIRMATION
screen.
Press [ENT] to delete or [ESC] to abort.
The R-2500NS series has a Job name of the “PENTAX” as its default setting.
Therefore, each data is stored in “PENTAX” unless another new Job name is
created. When another Job name is created, each data is stored in the new Job name.
3.5 All Clear
Select 5. All Clear by pressing the down arrow key.
Press [ENT] to view its screen.
Warning: When [CLEAR] is pushed, all JobFiles are deleted.
NOTE: - Creating several new JOB files and writing-in or rewriting data on the same
JOB files repeatedly may cause the time of writing-in and rewriting of the data to be
slower.
- Saving data when the memory capacity is almost full, and then deleting some JOB
files in order to secure open memory capacity, may cause the time of writing-in and
rewriting the data to be slower.
- In case the time of writing-in or rewriting the data becomes slower, send
the necessary data to PC for backup, then enter ‘All Clear’ in FILE MANAGER.
The above procedure will format the inside memory automatically and improve the time
or writing-in and rewriting the data. Beware that all JOB files will be deleted.
To Next Page
Loading...
Need help?
General
