139
When “LARGE CHARACTOR”is selected, result
information is shown with two screens and these
screens and the Graphics screen can be switched by
pressing [ENT].
14.7 Request aiming selection
Select 7.REQUEST AIMING and press [ENT] to
view the REQUEST AIMING selection window.
Press [ENT] to select and press [F5][ACCEPT].
After pressing [ENT] on STATION POINT
H.ANGLE SETUP screen, you can choose whether
or not the warning message, “Did you aim at Ref.
Point? “ is displayed.
14.8 EDM settings selection
Select 8.EDM SETTINGS and press [ENT] to view
the EDM SETTINGS selection window.
Press [ENT] to select and press [F5][ACCEPT].
To Next Page
Loading...
