42
Aim at Point 1.
Press [ENT] to view the KNOWN POINT
COORD.SETUP screen.
Press [ENT] to open the PN,X,Y,Z and PH input
window and input each.
Then, press [ENT] or [F5][ACCEPT] to view the
MEASURE screen.
Press [ENT] to view the ADD/CALC. SELECTION
MENU screen.
(Measuring is not needed. Just press [ENT].)
Press the [F1][ADD] to view the KNOWN POINT
COORD. SETUP screen.
Aim at Point 2, 3 and 4.
In the same manner, input the values of Point 2, 3
and 4.
[F3][P2 MEAS] button appears on 3
rd
point of
ADD/CALC.SELECTION MENU screen.
To Next Page
Loading...
