21
If PointCode exists, you can easily select it from the
list.
For using PointCodeList, please refer to “5.4.1 Point
Code”.
After pressing [ENT], you can edit Point Code data.
Input your desired PC name by pressing keys, and press [ENT] to view next screen.
If “PROCESS TYPE” is selected in “Action method selection”, after input/confirm PC data
the input POT1 data will automatically be stored in the memory. Then the panel
“STATION POINT H.ANGLE SETUP” will be displayed.
But, if “STRUCTURE TYPE” is selected in “Action method selection”, it is necessary to
press [ACCEPT] to proceed to next panel.
4.1.3 Point selection from the list
Inputting coordinate information can be done
manually and also by calling known points.
Press [F2][LIST] on STATION POINT SETUP
screen to display POINT SELECTION FROM THE
LIST screen
• [DELETE] Key
To delete the points being displayed
Press [F1][DELETE] to display
POINT DELETION screen.
Press [ENT] to delete the selected point from job file.
Press [ESC] to return STATION POINT SETUP.
To Next Page
Loading...
Need help?
General
