13
2.3 Typical Function keys of PowerTopoLite
Following function keys are typical of PowerTopoLite and each function key is described for
each function in this Manual.
Views another function combination.
Selects the Character and moves to next input at PN input etc.
Enters the displayed values without new Coordinates value input etc.
Inputs your desired Horizontal angle.
Views the BSP SETUP screen to input its Coordinates.
Measures and then saves input data.
Changes the Point name or Prism height.
Views your aiming point Coordinates.
Views the Target Coordinates adding the offset values.
Returns to the STATION POINT SETUP screen.
Returns to the STATION POINT H.ANGLE SETUP screen.
Views the POINT SELECTION FROM THE LIST screen.
Views the JOB LIST SEARCH screen.
Returns to original size.
Magnifies the graphics size.
Reduces the graphics size.
Views the GRAPHICAL VIEW screen.
Views point or point & graphic or point & point name or all.
Views the POINT DELETION screen.
Views the PN search screen by inputting the Point name.
Allow you to add more points for free stationing.
Starts the calculation of free stationing.
Views the next known point Coordinates setup screen.
Views the TARGET POINT screen.
Selects the EDM settings.
Selects all points of the current job.
The order of selected points.
To Next Page
Loading...
Need help?
General
