30
Input ppm value.
Press [ENT].
TEMP, PRESS and ppm input depend on the “Initial setting 1”
(ATM INPUT, ppm INPUT, NIL).
4.6 Station Orientation
Press the [F5][ACCEPT] to view the STATION
POINT H. ANGLE SETUP screen.
Input your desired H.angle.
• [INPUT] key
Input your desired H.angle.
Please note, that the rotation of the “H.angle”
depends on the rotation setting of
“Coordinate axis definition”.
• [INVERS] key
If you want to calculate direction angle, Press
[F5][INVERS] to jump to INVERSE function.
Input SP as station point, EP as back sight point.
Result angle is set here automatically by pressing
[ENT] at RESULT OF INVERSE screen.
Press [ENT] after aiming back sight point.
Aim at the reference point and press [ENT] to view
the MEASURE screen.
To Next Page
Loading...
