117
Select the file you desire to output, then press [ENT].
New files are created in the memory of the
instrument and SD card, and also transferred data
will be recorded in it.
[File Name]
Rectangular Data [Job Name]_C.[Extension]
Polar Data [Job Name]_P.[Extension]
NOTE: If free memory space becomes less than 1MB, you can not create the file, and an
error message [Space capacity is short] is displayed. Try again after increasing free
memory space.
13.1.2 Reading from Text File
This command allows you to transfer the text file
containing measurement point data in the internal
memory of the instrument or SD card to the data that
can be used with the instrument.
3.Select Rect. Data Text Read, then press [ENT]
Select the format of the file you desire to read and
data save place, then press [ENT]
[FORMAT SELECTION]
• DC1 (Extension DC1)
• CSV (Extension CSV)
• ExtCSV (Extension CSV)
[DATA SAVE PLACE]
INTERNAL
Read the file in the internal memory of the
instrument.
SD CARD
Read the file in the SD
To Next Page
Loading...
Need help?
General
