57
After you finish with sighting the reference point,
press [ENT] to go to the next screen.
Input three coordinates points on each screen of P1,
P2 and P3 to make a circle.
The procedure of inputting the points is the same as
that of STATION POINT SETUP .
After you finish with the input, press [F1][SAVE] or
[F5][ACCEPT] to display the measurement screen.
Sight the target, Press [F1][MEAS] to measure the
distance. From the measurement results, the distance
from the target to the circumference is displayed.
To Next Page
Loading...
