ELECTRICAL EQUIPMENT 23C
Data and dimensions
Note: This information is given as a guide for personnel engaged on engine overhauls. The dimensions
which are shown are those which are mainly used in the factory. The information applies to all engines,
unless an engine type code is shown.
Electrical equipment
The information which follows is general and can change with specific applications.
Starting aid
Type . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Electrically operated heater, with a fuel supply
Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12V (dropping resistor used on 24V system)
Flow rate of fuel through starting aid . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3,5/5,9 ml/min
Perkins Phaser/1000 Series, April 1995 23C.05
To Next Page
Loading...
