Perkins Phaser Series - Page 332

24B AUXILIARY EQUIPMENT
Power steering pump
To remove and to fit24B-01
To remove
1 Disconnect the pipe connections at the power
steering pump and fit covers to the open ends of
the pipes.
2 Release the setscrews and remove the pump. If
the pump is fitted to the rear of the compressor,
ensure that the drive coupling is not lost.
To fit
1 Renew the "O" ring and lubricate it with clean
engine lubricating oil.
2 Check the drive coupling or the gear for wear or
for damage. Renew it, if necessary.
3 If necessary, fit the drive coupling to the end of
the compressor shaft and rotate the pump shaft to
align the drive with the coupling. Fit the pump to the
compressor and tighten the setscrews.
4 Remove the covers from the open ends of the
pipes.and connect the connections.
24B.02 Perkins Phaser/1000 Series, April 1995