Philips BiPAP AVAPS - 7.2.10 Replacing the Slider Docking Latch; Figure 7-16: Heater Plate Assembly; 1. Remove the Humidifier Tank Assembly. Refer to Replacing the Water Chamber Assembly.; 2. Remove the Flip Lid Assembly. Refer to Replacing the Flip Lid Assembly.

PAGE 7-18
1118824, VER. 00
7.2.10 REPLACING THE SLIDER DOCKING LATCH
FIGURE 7-16: HEATER PLATE ASSEMBLY
To remove the Heater Plate Assembly:
1. Remove the Humidifier Tank Assembly. Refer to Replacing the Water Chamber Assembly.
2. Remove the Flip Lid Assembly. Refer to Replacing the Flip Lid Assembly.
3. Remove the Dry Box Assembly with Inlet Seal. Refer to Replacing the Dry Box Assembly/Humidi-
fier Inlet Seal.
4. Remove the Top Housing. Refer to Replacing the Humidifier Top Housing.
5. Remove the Outside Cover. Refer to Replacing the Humidifier Outside Cover.
6. Remove the Humidifier Bottom Housing. Refer to Replacing the Humidifier Bottom Housing.
7. Remove the Heater Plate Assembly.
To install the Heater Plate Assembly:
Included in Kit Tools Required
• Bottom Housing (with Left Side Panel)
• #6 X 1/4” screw (x4)
• T8 Torx Screwdriver
• T15 Torx Screwdriver