Philips BiPAP AVAPS - 6.1.7 Replacing the End Panel; Figure 6-10: Outside Cover; 1. Remove the UI Knob. Refer to 6.1.2.; 2. Remove the Top Cover. Refer to Replacing the Top Cover.

PAGE 6-111118824, VER. 00
6.1.7 REPLACING THE END PANEL
FIGURE 6-10: OUTSIDE COVER
To remove the Outside Cover:
1. Remove the UI Knob. Refer to 6.1.2.
2. Remove the Top Cover. Refer to Replacing the Top Cover.
3. Slide the Outside Cover out of the Bottom Enclosure.
To Install the Outside Cover:
1. Slide the Outside Cover into the Bottom Enclosure.
2. Assemble the remainder of the device as instructed in previous sections.
Included in Kit Tools Required
End Panel T15 Torx screwdriver