Philips BiPAP AVAPS - Chapter 5: Troubleshooting and Error Codes; 5.1 Reading the Device’s Error Log; 1. Connect the device to a PC. Refer to Chapter 1 for information on connecting the device to a PC.; 2. Apply power to the device.

PAGE 5-11118824, VER. 00
CHAPTER 5: TROUBLESHOOTING AND ERROR CODES
5.0 INTRODUCTION
This section provides instructions for viewing and clearing the devices’ error log, a description of the error
codes and bench checkout procedure.
5.1 READING THE DEVICE’S ERROR LOG
Error codes can be viewed on a PC using Service Center Tools or on the device’s display. Refer to Chapter 1
of this Service Manual for additional information on obtaining the Service Center Tools software and
connecting the device to a PC.
To read the device’s error log, perform the following:
1. Connect the device to a PC. Refer to Chapter 1 for information on connecting the device to a PC.
2. Apply power to the device.
3. Open Service Center Tools from the Windows Start menu.
F
IGURE 5-1: START MENU