Philips BiPAP AVAPS - 5. Continue following the on-screen prompts.; Figure 8-13: Increase;Decrease Flow; 6. When prompted, connect any CPAP device capable of delivering 20 cm H2 O to the Flow Meter using 18” patient tubing. The program will now calibrate negative flow.; Figure 8-14: Apply Negative Flow Source

PAGE 8-12
1118824, VER. 00
5. Continue following the on-screen prompts.
FIGURE 8-13: INCREASE/DECREASE FLOW
6. When prompted, connect any CPAP device capable of delivering 20 cm H
2
O to the Flow Meter
using 18” patient tubing. The program will now calibrate negative flow.
FIGURE 8-14: APPLY NEGATIVE FLOW SOURCE
NOTE
Be sure the CPAP device being used for negative flow is set to
20 cm H
2
O and turned on.
Click Here