Philips BiPAP AVAPS - Chapter 7: Humidifier Repair and Replacement; 7.1 Bench Checkout; 1. Visually inspect the outside of the device for physical damage and broken or missing parts.; 2. Connect the Humidifier to the NIV device and verify that the Heater Plate works (i.e., does it get warm?)

PAGE 7-11118824, VER. 00
CHAPTER 7: HUMIDIFIER REPAIR AND REPLACEMENT
This section illustrates the names and locations of the replaceable components in the System One Humidifier.
7.0 HUMIDIFIER REPLACEMENT PART (RP) KITS
7.1 BENCH CHECKOUT
Prior to performing repair and replacement procedures on the device:
1. Visually inspect the outside of the device for physical damage and broken or missing parts.
2. Connect the Humidifier to the NIV device and verify that the Heater Plate works (i.e., does it get
warm?)
3. Perform repairs to the device as necessary.
WARNING
To prevent electrical shock, disconnect the Humidifier from the
NIV device before attempting to make any repairs.
CAUTION
Components used in this device are subject to damage from static electricity.
Repairs made to this device must be performed only in an antistatic, Electro-
Static Discharge (ESD) protected environment.
RP KIT NAME PART NO. RP KIT NAME PART NO.
Dry Box Assembly 1064803 Inlet Seal (included w/Dry Box Seal) 1064804
Dry Box Seal (included w/Inlet Seal) 1064804 Outside Cover 1064808
Flip Lid Assembly 1064805 Slider Docking Latch 1064797
Heater Plate 1064806 Top Seal 1064798
Heater Plate Spring 1064807 Torx Screwdriver Kit 1040889
Humidifier Bottom Housing 1064799 Water Chamber (Dom. U.S.) 1063785
Humidifier Lower Base 1064800 Water Chamber (Int’l) 1066737
Humidifier Top Housing 1064801 Humidifier Tank Top Seal 1064798