Philips BiPAP AVAPS - 6.1.13 Replacing the Humidifier Cable; Figure 6-18: Humidifier Cable; 1. Remove the UI Knob. Refer to Replacing the User Interface (UI) Knob.; 2. Remove the Top Cover. Refer to Replacing the Top Cover.

PAGE 6-20
1118824, VER. 00
6.1.13 REPLACING THE HUMIDIFIER CABLE
FIGURE 6-18: HUMIDIFIER CABLE
To remove the Humidifier Cable:
1. Remove the UI Knob. Refer to Replacing the User Interface (UI) Knob.
2. Remove the Top Cover. Refer to Replacing the Top Cover.
3. Remove the Main PCA. Refer to Replacing the Main PCA.
4. Remove the Blower Cap. Refer to Replacing the Blower Cap.
5. Remove the Right Panel Assembly. Refer to Replacing the Right Panel Assembly.
To install the Humidifier Cable:
1. Place the Humidifier Cable into the Bottom Enclosure. Be sure the Humidifier Cable is properly
seated in its mounting location.
2. Assemble the remainder of the device as instructed in previous sections.
Included in Kit Tools Required
• Humidifier Cable • T8 Torx screwdriver
• T15 Torx screwdriver
Verify that key is
facing upwards
during installation.