Philips BiPAP AVAPS - 6.1.6 Replacing the Keypad; Figure 6-9: Keypad; 1. Remove the UI Knob. Refer to Replacing the User Interface (UI) Knob.; 2. Remove the Top Cover. Refer to Replacing the Top Cover.

PAGE 6-10
1118824, VER. 00
6.1.6 REPLACING THE KEYPAD
FIGURE 6-9: KEYPAD
To remove the Keypad:
1. Remove the UI Knob. Refer to Replacing the User Interface (UI) Knob.
2. Remove the Top Cover. Refer to Replacing the Top Cover.
3. Remove the Keypad from the Top Cover.
To install the Keypad:
1. Place the Keypad in the Top Cover.
2. Assemble the remainder of the device as instructed in previous sections.
Included in Kit Tools Required
Keypad T15 Torx screwdriver
UI Knob
Keypad