Philips BiPAP AVAPS - 2. Align the stands located on the bottom of the Blower Assembly with the holes in the Blower Housing.; Figure 6-15: Blower Installation; 3. Gently push the Blower Assembly into the Blower Housing.; 4. Properly seat the Blower Outlet Bellows in the Blower Housing.

PAGE 6-171118824, VER. 00
2. Align the stands located on the bottom of the Blower Assembly with the holes in the Blower Hous-
ing.
F
IGURE 6-15: BLOWER INSTALLATION
3. Gently push the Blower Assembly into the Blower Housing.
4. Properly seat the Blower Outlet Bellows in the Blower Housing.
5. Assemble the remainder of the device as instructed in previous sections.