Philips BiPAP AVAPS - 7.2.1 Replacing the Water Chamber Assembly; Figure 7-1: Water Chamber Assembly; 1. Gently squeeze the latch on the Flip Lid Assembly to release it and lift the Flip Lid Assembly.; 2. Pull the Humidifier Tank Assembly out of the Humidifier.

PAGE 7-31118824, VER. 00
7.2.1 REPLACING THE WATER CHAMBER ASSEMBLY
FIGURE 7-1: WATER CHAMBER ASSEMBLY
To remove the Water Chamber Assembly:
1. Gently squeeze the latch on the Flip Lid Assembly to release it and lift the Flip Lid Assembly.
2. Pull the Humidifier Tank Assembly out of the Humidifier.
To Install the Humidifier Tank Assembly:
1. With the Flip Lid Assembly in the up position, push the Tank Assembly into the Humidifier.
2. Be sure the Tank assembly is fully seated with the Dry Box Seal.
3. Close the Flip Lid Assembly.
Included in Kit Tools Required
• Tank Assembly
None