Philips BiPAP AVAPS - Chapter 4: Setup; 4.0.1 Supplying AC Power to the Device; 1. Plug the socket end of the AC power cord (included) into the power supply (also included).; 2. Plug the pronged end of the AC power cord into an electrical outlet that is not controlled by a wall switch.

PAGE 4-11118824, VER. 00
CHAPTER 4: SETUP
This chapter provides an overview of the system setup including introductory information on the User and
Provider modes and menus.
4.0 SUPPLYING POWER TO THE DEVICE
4.0.1 SUPPLYING AC POWER TO THE DEVICE
Complete the following steps to operate the device using AC power.
1. Plug the socket end of the AC power cord (included) into the power supply (also included).
2. Plug the pronged end of the AC power cord into an electrical outlet that is not controlled by a wall
switch.
3. Plug the power supply cord’s connector into the power inlet on the back of the device.
4. Ensure that all connections are secure.
WARNING
• Inspect the power cord often for any signs of damage.
Replace a damaged power cord immediately.
• Do not use extension cords with this device.
• Be sure to route the power cord to the outlet in a way that
will prevent the cord from being tripped over or interfered
with by chairs or other furniture.
• This device is activated when the power cord is connected.
CAUTION
If the device has been exposed to either very hot or very cold
temperatures, allow it to adjust to room temperature
(approximately two hours) before beginning setup.
NOTE
• Please refer to the User Manual for additional information.
• If you are servicing the device with a System One Heated Humidifier,
refer to the instructions included with the humidifier for details on how
to supply power to the device and humidifier.
NOTE
To remove AC power, disconnect the power
supply cord from the electrical outlet.