Philips BiPAP AVAPS - 1. Place the Heater Plate Assembly into the Humidifier Lower Base as shown in Figure 7-14. Be sure that the Heater Plate Spring is properly seated under the Heater Plate.; Figure 7-14: Heater Plate Installation; 2. Secure the Bottom Housing to the Lower Base using the four #6 x 1;4” screws and assemble the remainder of the device as necessary.

PAGE 7-16
1118824, VER. 00
1. Place the Heater Plate Assembly into the Humidifier Lower Base as shown in Figure 7-14. Be sure
that the Heater Plate Spring is properly seated under the Heater Plate.
FIGURE 7-14: HEATER PLATE INSTALLATION
2. Secure the Bottom Housing to the Lower Base using the four #6 x 1/4” screws and assemble the
remainder of the device as necessary.
The Heater Plate Assembly is
secured by two small tabs.