Philips BiPAP AVAPS - Figure 6-8: Screw Location; 1. Place the Top Cover onto the Bottom Enclosure.; 2. Hold the device together and turn it over to expose its bottom.; 3. Secure the Top Cover to the Bottom Enclosure using the two #6 X 1-3;4” screws. Torque screws to 10 in-lbs.

PAGE 6-91118824, VER. 00
FIGURE 6-8: SCREW LOCATION
To install the Top Cover:
1. Place the Top Cover onto the Bottom Enclosure.
2. Hold the device together and turn it over to expose its bottom.
3. Secure the Top Cover to the Bottom Enclosure using the two #6 X 1-3/4” screws. Torque screws to
10 in-lbs.
4. Assemble the remainder of the device as instructed in previous sections.
6.1.5 REPLACING THE UI PANEL
TO REMOVE THE USER INTERFACE PANEL
1. Remove the UI Knob. Refer to the Replacing the UI Knob section.
2. Gently peel back the User Interface Panel from the Top Cover
3. Remove any residual adhesive from the Top Cover.
T
O INSTALL THE USER INTERFACE PANEL
1. Remove the protective backing from the new User Interface Panel
2. Install the User Interface Panel to the Top Cover ensuring the Panel fits within the recessed area.
NOTE
The SD Card Slot Cover is loosely installed in the Top
Cover. Use care when removing the Top Cover so as
not to lose the SD Card Slot Cover.
Torque screws to 10 in-lbs
during installation.