Philips BiPAP AVAPS - 6.1.10 Replacing the Blower Assembly and;or the Blower Outlet Bellows; Figure 6-14: Blower Assembly and Blower Outlet Bellows; 1. Remove the UI Knob. Refer to Replacing the User Interface (UI) Knob.; 2. Remove the Top Cover. Refer to Replacing the Top Cover.

PAGE 6-16
1118824, VER. 00
6.1.10 REPLACING THE BLOWER ASSEMBLY AND/OR THE BLOWER OUTLET BELLOWS
FIGURE 6-14: BLOWER ASSEMBLY AND BLOWER OUTLET BELLOWS
TO REMOVE THE BLOWER ASSEMBLY/OUTLET BELLOWS:
1. Remove the UI Knob. Refer to Replacing the User Interface (UI) Knob.
2. Remove the Top Cover. Refer to Replacing the Top Cover.
3. Remove the Main PCA. Refer to Replacing the Main PCA.
4. Remove the Blower Cap.Refer to Replacing the Blower Cap
5. Lift the Blower Assembly out of the Blower Housing. Remove the Blower Outlet Bellows from the
Blower Assembly.
To install the Blower Assembly/Outlet Bellows:
1. Place the Outlet Bellows onto the Blower Assembly.
Included in Kit Tools Required
• Blower Assembly
• Blower Outlet Bellows
• T8 Torx screwdriver
• T15 Torx screwdriver
Blower and Blower
Outlet Bellows
Removed from Device