Philips BiPAP AVAPS - 1. Place the Bottom Housing onto the Lower Base Assembly.; 2. Verify that the Heater Plate Wiring Harness is properly routed in the Lower Base Assembly and not at risk of being pinched or damaged.; 3. Using the four #6 x 1;4” screws, secure the Bottom Housing to the Lower Base Assembly. Torque the screws to 5 in.-lbs.

PAGE 7-14
1118824, VER. 00
1. Place the Bottom Housing onto the Lower Base Assembly.
2. Verify that the Heater Plate Wiring Harness is properly routed in the Lower Base Assembly and not
at risk of being pinched or damaged.
3. Using the four #6 x 1/4” screws, secure the Bottom Housing to the Lower Base Assembly. Torque
the screws to 5 in.-lbs.
CAUTION
Route the Heater Plate wiring harness so as not to cause
damage during installation of the Humidifier Bottom Housing.