Philips BiPAP AVAPS - Figure 7-4: Dry Box Seal Removal; 1. Insert the narrow side of the Dry Box Seal into the Dry Box Assembly.; 2. Verify that the Dry Box Seal is fully Seated in the Dry Box Assembly.; Figure 7-5: Dry Box Seal Installation

PAGE 7-6
1118824, VER. 00
FIGURE 7-4: DRY BOX SEAL REMOVAL
TO INSTALL THE DRY BOX SEAL:
1. Insert the narrow side of the Dry Box Seal into the Dry Box Assembly.
2. Verify that the Dry Box Seal is fully Seated in the Dry Box Assembly.
F
IGURE 7-5: DRY BOX SEAL INSTALLATION
It is not necessary to
remove the Flip Lid
Assembly.
Narrow Side of the Seal