Philips BiPAP AVAPS - 4. Select Read Error Log from the drop-down menu.; Figure 5-2: Service Center Tools; 5. The device’s stored error codes will be displayed on the PC monitor.; 5.2 Clearing the Device’s Error Log

PAGE 5-2
1118824, VER. 00
4. Select Read Error Log from the drop-down menu.
FIGURE 5-2: SERVICE CENTER TOOLS
5. The device’s stored error codes will be displayed on the PC monitor.
5.2 CLEARING THE DEVICE’S ERROR LOG
To clear the device’s error log, perform the following:
1. Connect the device to a PC. Refer to Chapter 1 for information on connecting the device to a PC.
2. Apply power to the device.
3. Open Service Center Tools from the Windows Start menu.
4. Select Clear Error Codes from the drop-down menu.