Philips BiPAP AVAPS - 6.1.9 Replacing the Blower Cap; Figure 6-13: Blower Cap; 1. Remove the UI Knob. Refer to section 6.1.2.; 2. Remove the Top Cover. Refer to Replacing the Top Cover.

PAGE 6-14
1118824, VER. 00
6.1.9 REPLACING THE BLOWER CAP
FIGURE 6-13: BLOWER CAP
To remove the Blower Cap:
1. Remove the UI Knob. Refer to section 6.1.2.
2. Remove the Top Cover. Refer to Replacing the Top Cover.
3. Remove the Main PCA. Refer to Replacing the Main PCA.
Included in Kit Tools Required
• Blower Cap
• #4 x 1/2” screw (x7)
• T8 Torx screwdriver
• T15 Torx screwdriver
Torque screws to 7 in-lbs
during installation.