Philips BiPAP AVAPS - 6.1.12 Replacing the Right Panel Assembly; Figure 6-17: Right Panel Assembly; 1. Remove the UI Knob. Refer to Replacing the User Interface (UI) Knob.; 2. Remove the Top Cover. Refer to Replacing the Top Cover.

PAGE 6-191118824, VER. 00
6.1.12 REPLACING THE RIGHT PANEL ASSEMBLY
FIGURE 6-17: RIGHT PANEL ASSEMBLY
To remove the Right Panel Assembly:
1. Remove the UI Knob. Refer to Replacing the User Interface (UI) Knob.
2. Remove the Top Cover. Refer to Replacing the Top Cover.
3. Remove the Main PCA. Refer to Replacing the Main PCA.
4. Remove the Blower Cap. Refer to Replacing the Blower Cap.
5. Remove the Flow Manifold. Refer to Replacing the Flow Manifold.
6. Lift the Right Panel Assembly out of the Bottom Enclosure.
To install the Right Panel Assembly:
1. Slide the Right Panel Assembly into the Bottom Enclosure.
2. Place the Flow Manifold onto the Right Panel Assembly as shown in Figure 6-17.
3. Assemble the remainder of the device as instructed in previous sections.
Included in Kit Tools Required
• Right Side Assembly • T8 Torx screwdriver
• T15 Torx screwdriver