Philips BiPAP AVAPS - 6.1.16 Replacing the Sound Abatement Foam; Figure 6-21: Sound Abatement Foam; 1. Remove the UI Knob. Refer to Replacing the User Interface (UI) Knob.; 2. Remove the Top Cover. Refer to Replacing the Top Cover.

PAGE 6-24
1118824, VER. 00
6.1.16 REPLACING THE SOUND ABATEMENT FOAM
FIGURE 6-21: SOUND ABATEMENT FOAM
TO REMOVE THE SOUND ABATEMENT FOAM:
1. Remove the UI Knob. Refer to Replacing the User Interface (UI) Knob.
2. Remove the Top Cover. Refer to Replacing the Top Cover.
3. Remove the Main PCA. Refer to Replacing the Main PCA.
4. Remove the Blower Cap. Refer to Replacing the Blower Cap.
5. Remove the Blower Assembly. Refer to Replacing the Blower Assembly and/or the Blower Outlet
Bellows.
6. Remove the Right Panel Assembly. Refer to Replacing the Right Panel Assembly.
7. Remove the Humidifier Cable. Refer to Replacing the Humidifier Cable.
8. Remove the Blower Housing. Refer to Replacing the Blower Housing.
9. Lift the Foam out of the Bottom Enclosure.
TO INSTALL THE SOUND ABATEMENT FOAM:
1. Place the Foam in the Bottom Enclosure as shown in Figure 6-21.
2. Assemble the remainder of the device as instructed in previous sections.
Included in Kit Tools Required
• Sound Abatement Foam • T8 Torx screwdriver
• T15 Torx screwdriver