Philips FM20 - Generating a Configuration Report

4 Understanding Configuration Settings
17
Generating a Configuration Report
Avalon FM
Rel. G.0 or
later
The Support Tool lets you generate a configuration report in .pdf format. The .pdf files generated by
the Configuration Editor can be opened with Adobe Reader 6.0 or later. The latest version of the
Adobe ReaderTM is available for free at the Adobe website:
http://www.adobe.com/products/acrobat/readstep2.html
Currently, configuration reports can only be generated in languages that use the Roman 8 character set,
i.e. Western European languages.
Before you generate a configuration report, you must also be aware of the following limitations:
• Viewing individual configuration settings and generating a detailed configuration report is only
supported for configurations that were cloned from Avalon fetal monitors with software release
G.0 or later.
• Settings marked with an asterisk (*) may not be accurately displayed in the Configuration Editor, or
in configuration reports.
To generate a configuration report:
1 Open the configuration in the Configuration Editor.
2 Check the configuration for annotated settings. If necessary correct the annotated setting,
following the procedure described under
Correcting Annotated Settings in the Support Tool
Instructions for Use.
3 If you do not want to show all settings in the report, define the selection of settings that should be
included, see “Selecting the Settings Included in a Configuration Report” on page 19.
4 Select File > Configuration Report. This opens the Configuration Report Options window.
5 Select a format in the drop-down box Page Size. Possible choices are A4, and Letter. The Highlight
Options
on this page are not applicable for Avalon fetal monitors.
6 The file name and location on the hard drive where the configuration report will be saved to is
shown under
Save pdf file as. To change the file name or location, click on Change file name, select
a location on your hard drive, type in a file name, and select
OK.
7 Open the configuration report.