6 Monitor Settings
74
NST Report Recording Use Models
In the following use models, the NST trace interpretation and the NST Report can run in the
background. The main difference of these use models is to either use the
NST Report online on the
Avalon fetal monitor’s screen, or to print out the
NST Report and traces on paper.
There are two menus where you can customize the
NST Report recording to your institution’s
preference, in the
Setup NST Report menu, and in the Fetal Recorder menu.
Setup NST Report Menu Settings
Main Setup > NST Report > Setup > Setup NST Report > Report Recording > Immediately see: “Report
Recording” on page 72
Main Setup > NST Report > Setup > Setup NST Report > Auto Trace Rec > No see: “Auto Trace Rec.” on
page 72
Setup Fetal Recorder Menu Settings
Main Setup > Fetal Recorder > NST Autostart see: “NST Autostart” on page 66
Main Setup > Fetal Recorder > NST Autostop see: “NST Autostop” on page 66
Symbols
The following symbols are used in the following NST Report Recording use models:
• A green NST symbol indicates that the criteria are met.
• A yellow NST symbol indicates that the criteria are not met.
• A white NST symbol indicates that the NST report is ongoing.
Recording of Stored Data Traces
The maximum length of the stored trace will vary depending on the number of active measurements,
but will cover at least one hour of trace data. If you want to ensure that the whole trace is printed for
longer than one hour, it is recommended to start the recorder while NST trace interpretation is
running.
To Next Page
Loading...
