Philips FM20 - Standby Brightn.; TransportBrightn; Display Units; Alarm Limits

6 Monitor Settings
61
Standby Brightn.
The Standby Brightn. setting lets you choose a brightness setting for when the monitor is in Standby.
For
Standby Brightn., the choice Optimum is equivalent to 1.
TransportBrightn
FM20, FM30
with #25 only
The TransportBrightn setting defines the display brightness when the monitor is running on battery
power. For
TransportBrightn, the choice Optimum is equivalent to 4.
Display Units
If Display Units is set to Yes, the measurement units are displayed next to the measurement numerics,
provided that there is enough space.
Alarm Limits
If Alarm Limits is set to Yes, the alarm limits are displayed next to the measurement numerics, provided
that there is enough space.
Measurement Time
If Measurement Time is set to Timestamp, the time shown beside the numeric will show the time stamp
of the most recent measurement. If set to
Time to Next, and, mode of a measurement is set to Auto or
Sequence, the time until the next automatic measurement is shown, along with a graphic representation
of the remaining time.
NOTE
• If the numeric area on the monitor screen is configured large enough, the Timestamp or Time to
Next
will be displayed in the NBP segment. If this area is too small, the numeric may be shown
without the time.
• This setting is also accessible in
Main Setup > Measurements > NBP > Measurement Times.
NBP Sys/Dia only
Use the NBP Sys/Dia Only setting to define how the NBP values are presented on the Screen. Choices
are:
•
Yes for systolic/diastolic, e.g. 120/80
•
No for systolic/diastolic (mean), e.g. 120/80 (95)
Wave Line Style
The Wave Line Style setting lets you configure the thickness of all waves. For better visibility over a
distance you might want to use
Medium or Thick. The choices are:
•
Thin
• Medium
• Thick
• Extra Thick