Philips FM20 - Touch ToneVolume; Timer Volume; Global SmartKeys; Global SmartKeys Factory Defaults

6 Monitor Settings
59
Touch ToneVolume
The Touch Tone Volume setting defines the volume of the tone you hear every time you select a field on
the monitor's screen. You may want to set this to
0 if you want to operate the monitor in a quiet
environment.
Timer Volume
The Timer Volume setting determines the volume of the notification tone for the timer.
Global SmartKeys
Use the Global SmartKeys setting to define the selection and sequence of the SmartKeys on the Screen.
Global SmartKeys Factory Defaults
The Global SmartKeys appear by factory default in the following order:
•
Toco/IUP Bsl
• FRStart/Stop
• PaperAdvance
• Pat. Demogr.
• Enter Notes
• Strt/Stp NBP
1
• Stop All NBP
1
• Repeat NBP
1
• Pause Alarms/Alarms Off
• Stored Rec
• Standby
• Main Setup
• Timer
2
• NST Report
2
1
in monitors with NBP measurement only
2
in monitors with NST Trace Interpretation application (#C71) only
Global SmartKeys - Changing the Selection and Sequence
To change the selection of the Global SmartKeys:
1 Select Main Setup > User Interface > Global SmartKeys.
2 From the pop-up key line, select Add to open the Choices menu that contains all available
SmartKeys.
3 From the Choices menu, select the desired SmartKey. This adds the new key to the bottom of the
list of configured SmartKeys (on the left).
4 To delete a SmartKey from the list of configured SmartKeys, select it in the list, then select the
pop-up key
Delete.
5 To move a SmartKey to a different position, use the Sort Up and Sort Down pop-up keys.