Philips FM20 - Repeat Time; Mode; Setup Sequence; NBP

5 Measurement Settings
40
Repeat Time
Use the Repeat Time setting to define the repetition times for the Auto mode of NBP measurements.
This setting is only visible when
Mode is set to Auto.
Mode
Use the Mode setting to select the NBP measurement mode. Choices are Manual, Auto, or Sequence.
Setup Sequence
These settings are only visible if Mode is set to Sequence, and you select Setup Sequence in the Setup NBP
menu. This opens the
Setup Sequence window with the setting items:
•
Phase A
• Phase B
• Phase C
• Phase D
• every
You can then define up to four measurement cycles (phases A to D) which will run consecutively. For
each cycle you can set the number of measurements, and the interval between them. If you want to run
less than four cycles in a sequence, set the number of measurements for one or more cycles to
Off.
NBP
Use the NBP setting to switch the NBP measurement On or Off.
Stop All
This is not a setting.
Select
Stop All to to stop a single NBP measurement, Auto NBP measurements, or a Sequence of NBP
measurements
.
Veni Puncture
This is not a setting.
Select
Veni Puncture to start a Veni Puncture inflation.
Unit
Use the Unit setting to define the unit. Choices are mmHg and kPa.
Done Tone
Set Done Tone to On if you want to hear a short prompt tone at the completion of each NBP
measurement.
AnnouncementTone
Use the AnnouncementTone setting to switch the announcement tone for an NBP measurement that
starts in a CL NBP pod
On or Off.